Installation and Operation Instructions

A) YOUR PLASTIMAYD SPACE ARENA is made from the best materials available and is specifically designed for residential use ONLY. The air-inflated portion is transparent vinyl film specially formulated to resist weathering and sunlight deterioration, retain flexibility, and perform well with reasonable care. The replaceable zipper entry and cable hem is made of rip resistant vinyl-coated nylon.

B) INSTALLING THE SPACE ARENA

1. Position the SPACE ARENA box at the B/C corner as shown on the layout plan provided. Face the dome as indicated on the box arrow pointing toward pool. Remove dome from box being careful to keep it facing in the same direction as it came out of the box. Do not drag dome across any surface, it must always be lifted, or it may be permanently damaged.

2. Unfold the dome down the length of the pool.

3. Locate the opposite-end corners which will be lying on top at each of the folds. Two people should then grasp these two corners and pull them to the opposite side of the pool so that the entire pool is covered. Avoid letting water get on top of dome or resting the zipper in the water.

4. Place water tubes into perimeter sleeves and fill with water. After this is completed connect blower and inflate. To use the variable speed blower, simply position the blower housing under the water tube in the location desired. Plug the blower to 110 volt connection and inflate the SPACE ARENA. Once inflated, adjust the pressure in the dome using the control knob. It will be necessary to monitor the pressure in the SPACE ARENA and to make adjustments in the setting from time to time especially in warm or cold weather.

The SPACE ARENA should be firm and not easily swayed when outer pressure is applied. Note: Side walls of SPACE ARENA should be straight up and down, not bowed out. Too much air will cause the SPACE ARENA to grow and become distorted.

CAUTION: DO NOT OVERINFLATE

Over-inflation puts severe pressure on the seams, especially around the entry and can cause fatigue of the material and could cause permanent damage.

The replaceable zipper entry panel is designed to allow placement of the slider either at the top or at the bottom when closed. (For child safety).